Restore precise engine ignition timing, eliminate hard-starting issues, and prevent sudden engine stalling with this 100% Toyota Original Crankshaft Position Sensor Short Type (Part Number: 90919-05067). Engineered as a Toyota original direct electrical replacement (often called a pulley sensor), this premium sensor monitors the exact rotational speed and position of your crankshaft pulley, sending real-time data to the Engine Control Unit (ECU) to perfectly synchronize fuel injection and spark plug combustion cycles. [1, 2]

Unlike cheap aftermarket sensors that degrade under extreme under-hood engine heat, leak oil from their seals, or transmit weak, delayed electronic signals that trigger check engine lights (CEL), this Toyota original component is built with a heavy-duty magnetic core and a short-wire high-grade chemical-resistant composite housing. It delivers steady, high-precision electronic signals to keep your engine running smoothly in heavy city traffic. [1]

This short-type crankshaft sensor fits perfectly on the engine block pulley alignment of the following vehicle models running 1AZ and 2AZ engines:

A failing, weak, or dirty crankshaft position sensor is a severe driving hazard that can cause your vehicle to crank repeatedly without starting, idle extremely rough, or cut off completely while driving at high highway speeds. Even worse, low-quality generic aftermarket sensors can easily lose signal strength when the engine gets hot, putting your vehicle into dangerous limp mode or triggering constant diagnostic trouble codes (DTCs). This Toyota original 90919-05067 sensor guarantees permanent structural sealing, accurate timing alignment, and complete mechanical driving reliability. [1, 2, 3, 4]